In Egypt, the production of power and the associated environmental problems are starting to take the stage. One environmentally responsible way to lessen the power crisis is to employ renewable energy sources effectively and efficiently. This paper proposes to develop a hydrogen energy storage-based green (or environmentally friendly) power plant on many Egyptian cities such as Sohag city. To produce green hydrogen, the proposed power station uses energy storage, solar, and wind power. Energy storage systems are used to store extra energy produced by wind turbines and solar panels and to supply energy when the output of renewable energy is low. An optimized design of the proposed power plant uses hydrogen energy to satisfy peak load requirements and reduce GHG (greenhouse gas) emissions. Electrolysis is the method used in the proposed solar/wind power plant to create hydrogen. Water can be split into hydrogen and oxygen via electrolysis, a process that uses electricity. Renewable energy sources can be used to power this procedure, ensuring that the hydrogen produced is “green” and does not contribute to greenhouse gas emissions. The design of the power plant incorporates advanced electrolysis technology, such as proton exchange membrane (PEM) electrolyzers, which are efficient and well-suited for integrating with renewable energy sources.

To enhance the stability and reliability of the system, the converters’ parallel operation can be cascaded to address the constraints posed by the substantial integration of renewable resources. Buck-boost DC-DC converters are often controlled via a cascaded control approach to allow parallel operation. The converter’s output current and its voltage will be controlled by nested loop control. This study proposes adaptive droop control parameters that are updated and verified online using the principal current sharing loops to minimize the fluctuation in load current sharing. When the converters in the microgrid are paralleled, load sharing will be accomplished using the droop control approach in addition to nested proportional-integral-based voltage and current control loops. To restore the correct voltage across the DC microgrid, an outer addition voltage secondary loop will be used, rectifying any voltage disparities caused by the droop management strategy. Several common load resistances and input voltage variations are used to test the suggested method. Using a linearized model, this work assesses the stability and performance of the proposed method. It then confirms the findings with an adequate model created in MATLAB/SIMULINK, Real-Time Simulation Fundamentals, and hardware-based experiments.

A DC microgrid is an efficient way to combine diverse sources; conventional droop control is unable to achieve both accurate current sharing and required voltage regulation. This paper provides a new adaptive control approach for DC microgrid applications that satisfies both accurate current sharing and appropriate voltage regulation depending on the loading state. As the load increases in parallel, so do the output currents of the distributed generating units, and correct current sharing is necessary under severe load conditions. The suggested control approach raises the equivalent droop gains as the load level increases in parallel and provides accurate current sharing. The droop parameters were checked online and changed using the principal current sharing loops to reduce the variation in load current sharing, and the second loop also transferred the droop lines to eliminate DC microgrid bus voltage fluctuation in the adaptive droop controller, which is different and inventive. The proposed algorithm is tested using a variety of input voltages and load resistances. This work assesses the performance and stability of the suggested method using a linearized model and verifies the results using an acceptable model created in MATLAB/SIMULINK Software Version 9.3 and using Real-Time Simulation Fundamentals and hardware-based experimentation.